Multipurpose, two component, Polyurethane thin adhesive for fixing tiles and stone on interior and exterior floor & wall. Suitable for various drywall substrates including metals.

TDS OF PU ADHESIVE

Designed especially for interior and exterior floor and wall installations of all types of ceramic tile, vitreous, semi-vitreous tile, glass mosaic tiles, precast terrazzo, engineered stone, metal tiles and natural stones over concrete and on a variety of substrates including metal substrates and drywall boards.

FEATURES & BENEFITS

• Two components, just mix and use
• High strength, chemical resistant
• Economical & Easy to use
• Bonds to various substrates including metals
• Complies to EN/ISO with a R2T classification
• Water, freezing, thermal shock resistant
• Flexible and heat resistant

SUBSTRATES

•  Concrete Masonry & Brick Masonry 
• Cement Mortar Beds & Plaster 
• Metal floors and walls 
• Tile and Stone 
• Wood & Plywood 
• Cement Backer Board 
• Cement Terrazzo 
• Engineered stones & Marbles
• Epoxy or PU resin based substrates 
• Rubber, PVC and Linoleum substrates

PACKAGING

Pack Size : 5Kg & 10Kg

MIXING

Home Pride PU Adhesive is prepared by mixing together parts A and B from the bottom upwards, using a low-rev (≈ 400/min.) with the present ratio of 92.5:7.5 (1KG) of the packs. Pour part B into the bucket containing part A, being careful to mix the two parts uniformly until a smooth, even coloured mixture is obtained. The user must mix a quantity of adhesive which can be consumed within 1 hour at +25 °C / 50% R.H.

APPLICATION

Apply adhesive to the substrate with the flat side of the trowel, pressing firmly to work into surface. Comb on additional adhesive with the notched side. Use the proper sized notched trowel to ensure full bedding of the tile. Spread as much adhesive as can be covered with tile in 10 minutes. Back butter large format tiles (> 12”x12”) to provide full bedding and firm support. Place tiles into wet, sticky adhesive and beat in using a beating block and rubber mallet to imbed tile and adjust level. Check adhesive for complete coverage by periodically removing a tile and inspecting bedding adhesive transfer onto back of tile. If adhesive is skinned over (not sticky), remove and replace with fresh adhesive.

CLEANING

Tools and containers may be cleaned using water when the adhesive is still fresh. The hardened adhesive can be removed from tools mechanically. 

STORAGE & SHELF LIFE

PU Adhesive has a shelf life of 24 months when stored in normal dry conditions.

PRECAUTIONS

Keep it out of reach of children. Wear suitable protective clothing, gloves and eyes/face protection. After contact with skin, wash immediately with plenty of clean water. In case of contact with eyes rinse immediately with plenty of clean water and seek medical advice.